How-To Videos

Install a Foam
on a flat Gripper

Install a Foam
on a Gripper on the side

Replace Standard Foam

4 steps
- Remove old foam
- Remove protection sheet
- Apply new foam on bottom side
- Compress the gripper

INSTALL 
MAGNET PLATE

4 steps
- Remove the old foam
- Clean the bottom plate
- Remove the protection sheet
- Apply the magnet foam

How-To replace
a magnet Foam

4 steps
- Remove the old foam
- Roll the new foam
- Unroll the new foam
- Pick a non-porous plate

How-To Replace
a Magnet Foam with corners

4 steps
- Remove the old foam
- Roll the new foam
- Unroll the new foam
- Pick a non-porous plate

How-To Place 
Pins

Centering pins to help you (optional)

Adjust vacuum control

WARNING: VACUUM PRESSURE SHOULD NEVER EXCEED -400MB (12” HG)
TAMPERING WITH THE SPRING VALVE WILL VOID THE WARRANTY AND MAY DAMAGE THE BLOWER.
PLEASE CONTACT JOULIN BEFORE ADJUSTING THE SPRING VALVE.

4 steps
- Put the gripper in Reserve mode
- Be sure the vacuum gauge is at atmospheric pressure
- Set the level of vacuum
- Push the spring valve by hand